Electrical Connections - hanseatic HCDA19090DI Gebrauchsanleitung

Page EN-28 Start-up

Electrical connections

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Do not operate or continue to oper-
ate the appliance, if it
– shows visible signs of damage, e.g.
the mains cable is defective,
– starts smoking or there is a smell of
burning,
– makes unfamiliar noises.
In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our service de-
partment (see page EN-31).
■ When positioning the appliance, en-
sure the supply cord is not trapped
or damaged. Do not kink the supply
cord or lay it over sharp edges. This
can result in a break in the cable.
■ Do not locate multiple portable sock-
et-outlets or portable power supplies
at the rear of the appliance.
■ Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cate-
gory III must be connected within the
house installation with at least 3 mm
contact clearance; consult a qualifi ed
professional if necessary (see "Ser-
vice" on page EN-31).
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■ Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage to property!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■ If possible, do not tilt the cooling ap-
pliance horizontally.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible and properly installed socket (220–
240 V~ / 50 Hz).
You will find all important information
about operation from page EN-13.