ENGLISH
Defrosting of the freezer
Caution! Never use sharp metal
tools to scrape off frost from the
evaporator as you could damage
it.
Do not use a mechanical device or
any artificial means to speed up
the thawing process other than
those recommended by the
manufacturer.
Do not use the supplied ice
scraper to prepare food.
About 12 hours prior to defrosting
set a lower temperature in order
to build up sufficient chill reserve
in case of any interruption in
operation.
A certain amount of frost will always form on
the freezer shelves and around the top
compartment.
Defrost the freezer when the frost layer
reaches a thickness of about 3-5 mm.
1. Switch off the appliance or pull out
electrical plug from the wall socket.
2. Remove any stored food and put it in a
cool place.
Caution! A temperature rise
of the frozen food packs
during defrosting may
shorten their safe storage life.
Do not touch frozen goods
with wet hands. Hands can
freeze to the goods.
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if...
Problem
The appliance does not oper‐
ate.
3. Leave the door open. Protect the floor
4. In order to speed up the defrosting
5. When defrosting is complete, dry the
6. Switch on the appliance and close the
7. Set the temperature regulator to obtain
Only after this time put the food back into
the freezer compartment.
Period of non-operation
When the appliance is not in use for long
period, take the following precautions:
1. Disconnect the appliance from electricity
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent
Possible cause
The appliance is switched off. Switch on the appliance.
from the defrosting water e.g. with a
cloth or a flat vessel.
process, place a pot of warm water in the
freezer compartment. In addition,
remove pieces of ice that break away
before defrosting is complete. Use the
supplied ice scraper for this purpose.
interior thoroughly. Keep the ice scraper
for the future use.
door.
the maximum coldness and run the
appliance for at least 3 hours using this
setting.
supply.
unpleasant smells.
19
Solution