Programming Auto Heat Up; Stop & Go Function; Recall Function; Keep Warm Function - Novy Easy 1851 Bedienungsanleitung

Using the timer without cooking:
Timer without cooking
Switch on the hob.
Press for 2 seconds.
Wait 10 seconds
Select the timer
Press the timer indicator [000]
Reduce the time
Press [–] on the timer
Increase the time
Press [+] on the timer
After a few seconds the timer display stops flashing. The time is
selected and counting down starts.
Turn off automatically at the end of the cooking time:
As soon as the selected cooking time is up, the display will flash
000
, a beep will be heard. To stop the audible signal and the
flashing, press [–] or [+]on the timer.

4.3.6 Programming auto heat up

All cooking zones are equipped with an auto heat up function.
The cooking zone will initially operate at full power for a certain
amount of time before automatically reducing to the selected
power level.
Programming auto heat up:
Activating auto heat up
Glide your finger over the slider to (for example)
7
and hold for 3 seconds
Switching auto heat up off
Glide your finger over the slider
Auto heat up table
Set value for cooking time
1
2
3
4
5
6
7
8
9
Display
0 0 0
0 6 0‐
0 5 9...
0 0 1‐
0 0 2...
Display
7 A
Display
0 9
to 0‐9
Auto heat up function
Time (min:sec)
0:40
01:12
02:00
02:56
04:16
07:12
02:00
03:12
--:--
4.3.7 Stop & Go function
This function temporarily interrupts the activity of the hob and
allows a restart with the same settings.
Turning Stop & Go on and off:
Switching on
II
Press for 2 seconds.
Switching off
II
Press for 2 seconds.
Then press the animated slider

4.3.8 Recall function

After turning the hob off
to recall the last selected settings: (this up to a maximum of 10
seconds)
– State of all cooking zones (power)
– Minutes and seconds of the programmed cooking zones by
the timers
– "Automatic cooking" function

– Keep warm function

The recall procedure is as follows:
– Push the control key
II
– Push before the flashing stops.
The previous settings are now active again.
4.3.9 Keep warm function
This function makes it possible to automatically reach and
maintain a temperature of 70°C .
This prevents pans overflowing or your food sticking to the
bottom of the pans.
Switching the keep warm function on and off:
Switching on
Select the zone using the zone selection button
Press
Switching off
Select the zone using the zone selection button
Press
The maximum duration of the keep warm function is 2 hours.
– 50 –
Display
I I
0‐9
, it is possible
for 2 seconds.
Display
U
0