Establishing The Electrical Connection En; Connecting The Pneumatic System En - Abicor Binzel BRS-CC Betriebsanleitung

BRS-CC
NOTICE
• Ensure clear access to the control elements and connections.
• Protect the components against rain and direct sunlight.
• Use the device only in dry, clean and well-ventilated rooms.
1 Fix the support to a vibration-free working surface in the robot's work area with four screws.
6.2 Establishing the electrical connection
DANGER
Risk of injury and device damage due to improper connection
Improper connection to the earth rail of the system/building installation.
• Implement suitable measures as defined in the standards.
NOTICE
• These operating instructions describe multiple variations.
• Observe the provided circuit diagrams and optional wiring.
Three robot outputs 24 V DC and one robot input 24 V DC are required for controlling the valves.
A tactile (mechanically operated) valve is used for spraying.
NOTICE
• The gas nozzle diameter must match that of the prism.
• The distance sleeve must match the nominal diameter of the gas nozzle.
• The reamer must be precisely aligned with the torch type.
 13.1 Circuit diagram on page EN-28
6.3 Connecting the pneumatic system
NOTICE
• These operating instructions describe multiple variations.
• Observe the provided pneumatic plan and optional connections.
A compressed air hose with an outer diameter of Ø 10 mm (inner width of Ø 8 mm) is required for the supply line. A shut-off
valve in the supply line is recommended. This allows the BRS-CC to be quickly and simply depressurized in order to carry
out any installation and maintenance work.
 13.2 Pneumatic Plan on page EN-29
BAL.0109 • 2020-12-15
6 Commissioning
EN - 11