Installing An External Alarm; Operation - Dometic MC-Serie Montage- Und Bedienungsanleitung

Operation

1. Connect the plug of the connection cable into the AC mains.
✔ The green power LED lights up (fig. 2 2, page 3).
2. Press the button.
✔ The display turns on.
For the first two seconds the display will not show temperature values; it shows
"--.-". Then the temperature read from the sensor is shown.
6.5 Mounting and removing the door handle
1. Mount the handle as shown (fig. 7, page 6).
2. Remove the handle as shown (fig. 8, page 6).
6.6

Installing an external alarm

Use the floating contacts at the back of the refrigerator as follows:
• The upper contacts correspond to the power fail alarm (fig. 9 1 and 2, page 7).
• The lower contacts correspond to the temperature alarm (fig. 9 3 and 4,
page 7).
A voltage between 12 V and 250 V can be connected at the contacts. The maximum
load must not exceed 8 A. The minimum power rating is 100 mA/5 V.
I
NOTE
The external alarm signal can only be switched off by eliminating the
cause of the alarm.
7 Operation
7.1 Before first use
Before first use, clean the refrigerator inside and outside with a damp cloth for
hygienic reasons (see also chapter "Cleaning and maintenance" on page 22).
7.2 Saving energy
• Only open the mother milk cooler as often and for as long as necessary.
• For optimal energy consumption, position the shelves and drawers according to
their position on delivery.
18
MC302, MC502
EN