Variable Speed - Ryobi LDD-1802 Bedienungsanleitung

GB
F D E
OPERATION
BATTERY PROTECTION FEATURES
Ryobi 12 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool. Switching to a lower speed will also
prevent shut down.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
ADJUSTING THE TORQUE (Fig. 3)
The tool is equipped with an adjustable torque clutch for
driving different types of screws into different materials.
Adjust the torque as necessary.
SWITCH (Fig. 4)
n
To turn your drill ON, depress the switch trigger.
n To turn it OFF, release the switch trigger.

VARIABLE SPEED

This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
SWITCH LOCK (Fig. 4)
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch trigger,
place the direction of rotation selector (Forward/Reverse
Selector) in center position.
Note: When selector is in center position, switch trigger
is locked.
REVERSIBLE (Fig. 4)
This tool has the feature of being reversible. The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill held in normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilling
direction is reversed when the selector is to the right
961067016-02.indd 10 961067016-02.indd 10
I P NL S DK
English
N FIN GR H CZ
of the switch. When the selector is in center position,
the switch trigger is locked. To stop, release switch trigger
and allow the chuck to come to a complete stop.
ELECTRIC BRAKE
This drill has an electric brake. When the trigger switch
is released, the chuck stops turning. When the brake is
functioning properly, sparks will be visible through the
vent slots on the housing. This is normal and is the action
of the brake.
KEYLESS CHUCK (Fig. 5)
Your drill has a keyless chuck. As the name implies, you
can hand tighten or release drill bits in the chuck jaws.
Hold the body with one hand and rotate the chuck with
your other hand. The arrows on the chuck indicate which
direction to rotate the chuck body in order to LOCK
(tighten) or UNLOCK (release) the drill bit.
WARNING
Do not hold chuck body with one hand and use
power of the drill to tighten chuck jaws on drill
bit. Chuck body could slip in your hand or your
hand could slip and come in contact with rotating
drill bit. This could cause an accident resulting in
serious personal injury.
ADJUSTING THE SPEED (Fig. 6)
Follow these steps to adjust the speed.
n For high speed: Slide the two-speed gear train switch
to "2."
n
For low speed: Slide the two-speed gear train switch
to "1."
Note: If you have difficulty changing from one gear
range to the other, turn the chuck by hand until the
gears engage.
CAUTION
To prevent gear damage, always allow chuck to
come to a complete stop before changing the
speed or the direction of rotation.
7
RUS RO PL SLO HR
3/24/08 4:46:17 PM 3/24/08 4:46:17 PM
TR