TDK-Lambda HFE1600 Serie Bedienungsanleitung Seite 15

Notes:
Refer to Figure 1.
*1
*2 For cases where conformance to various safety standards (UL, EN etc.) is required, to be described as
100-240Vac (50/60Hz).
*3 At 115/230Vac, 25˚C ambient temperature.
*4 Not applicable for the noise filter inrush current less than 0.2mS.
*5 From 85~132Vac or 170~265Vac, constant load.
*6 From No-load to Rated load, constant input voltage. Measured at the sensing point in Remote sense.
*7 Measured with JEITA-RC9131A 1:1 probe with 2x270uF electrolytic capacitors and 1uF film capacitor on the
output, 20MHz B.W. When Power Supplies are installed in HFE1600-S1U shelf, measured with 1uF film
capacitor on the output terminals of the HFE1600-S1U.
*8 Voltage drop on load wires: HFE1600-12: 0.25V/wire; HFE1600-24: 0.5V/wire; HFE1600-32: 0.75V/wire;
HFE1600-48: 1V/wire.
*9 Accuracy applicable for load current > 50% of rated output current. Derate maximum output power by 5%.
*10 Inverter shut down method. Reset by AC voltage recycle or by On/Off control.
*11 Measured with JEITA-RC9131A 1:1 probe with 470uF electrolytic capacitor and 0.1uF film capacitor on the
output, 20MHz B.W. Capacitors are not required when the Power Supply is installed in HFE1600-S1U shelf.
*12 Measured according to UL, EN method at 60Hz, 25˚C ambient temperature.
*13 Open collector signal. Maximum sink current: 10mA, maximum voltage 15V.
*14 HFE1600 series considered as professional equipment and not intended for sale to general public.
*15 Refer to Output Power vs. temp derating figure A, B, C (Paragraph 1.2).
- 2 -