eta Dori Bedienungsanleitung Seite 20

GB
„ZERO" OR „TARE" FUNCTION
To weigh different loads consecutively without removing loads from the scale. Put first
Load on the scale, get weight reading. Press A5
before adding next load. Add another item and the display will read the added weight. You
can repeat this operation. If all products are taken away from the weighing plate,a negative
value will appear on the display.
Note 1: „ZERO" function
When total sum of all loads on scale ≤ 200 g, LCD will show „0" each
time is pressed. Icon „O" will show on upper left corner of LCD,
indicating „ZERO" function is active. Max. weight capacity remains
unchanged.
Note 2: „TARE" function
Exceeding loading capacity of the scale
Maximum weight for a product weighing is 5 kg. The display will show Err Error message
in case the weight of the product on the plate exceeds 5 kg. It means the product weight
exceeds the loading capacity of the scale.
Remove the excessive weight product from the scales to avoid damage to the appliance.
Error messages shown on the scale display
1. Lo — replace the batteries
2. Err — scale overload, the weight exceeds 5 kg
If symptoms such as flashing of the display or erroneous indications
appear, remove the scales away from disturbing sources (e.g.
microwave oven) or turn off the source for the term of weighing.
All manuals and user guides at all-guides.com
If the total weight is > 200 g, the display (after pressing the
button) will show the icon "T" in the upper left corner of the display,
which indicates the activity of the „TARE" mode. By pressing the
button in this mode, you will display the total amount of
weights/volumes of all items. If you wish to continue with TARE
weighing, just press the
The maximum capacity will decrease by the total weight of all
items.
Note:
After removing all items from the weighing surface, the display will
show the total number of weights/volumes with the "-" mark.
Auto shut off
Auto shut-off occurs if display shows ‚0' or shows the same weight
reading for 120 sec.
Attention
button to reset the LCD reading to „0"
button again to reset the display to 0.
20 / 39