Instruction Manual For Children Toy Scooter - byox EPIC Bedienungsanleitung

ENG
INSTRUCTION MANUAL FOR USE OF TOY SCOOTER
Model: EPIC / POP, Item No.: GW-TS-005 / GW-TS-003
WARNING! Read the manual carefully before use and keep it for future reference at a place away from the reach of
children! It contains important information, warnings and recommendations for the scooter and its safe use.
BEFORE USE__
This product complies with European standard EN 71 : 2014 .The materials used for the making of this product are
suitable and safe for children's health.
The scooter is intended to be used by only one child at a time and weighting up to 50 kg.Not suitable for children
under 3 years old.
This scooter is a toy and is not intended to be used for sport or riding on traffic roads . It is not suitable for jumps, stunts
or acrobatic roller sports.
WARNING! To be used only under an adult supervision. For domestic use only.
ASSEMBLY OF THE SCOOTER
WARNING This packaging contains small parts, which can cause choking or suffocation when swallowed. No small
!
children should be present during assembly of the scooter. This product is not suitable for children under 36 months, due
to the presence of small parts. The assembly must be performed by an adult only.
Remove the scooter from the box. Check it for scratches of the paint and/or indents, which may have occurred during
transport. The scooter is prepared and packaged by the manufacturer and there should not be any problems, even if
there are scratches or indents on the box.
WARNING! The toys is semi assembled. You should put the handlebar tube in the front hole of the deck.
Before use be assured that the handlebar is straight and fixed in the deck. If you want to release the handlebar , push the
locking part at the end of the handlebar tube and pull the handlebar in the opposite position.
In order to adjust the height of the handlebar first release the tightening bracket. Afterwards press the spring button,
which goes through the openings at the front. That way you release the handlebar so it is able to move up or down,
depending on the height you desire. Make sure that the button pops out through the respective opening of the height;
afterwards tighten the tightening bracket.
Assembly of the saddle - The saddle height should be adjusted according the height of the child.Usually start with the
shorter position of the saddle.The child should touch the ground freely with its feet, otherwise should not be able to stop
and will lose balance which can cause fall and injury of the child.
Warning! Keep your fingers and hands from the mechanisms, because there is danger of pinching upon assemble and
disassemble of the scooter.
__
1.Handlebar
2.Grips
3.Handlebar stem; T-bar
4.Rear mudguard / brake
5.Deck
6.Wheels and bearings
7.Spring button
8.Plastic Clamp
9.Saddle
6