Watching The Picture; Before You Start; Switching The Input Signal - Sony PFM-32C1 Bedienungsanleitung

Watching the Picture

Watching the Picture

Before you start

• Turn on the display.
• Turn on the connected equipment and play a video
source.
• To display the input signal information and Picture
Mode on the screen when turning on the power or
switching the input signal, set "Display" in the
Custom Setup menu to On.
• To select the on-screen language used in the menu,
see page 39 (GB).

Switching the Input Signal

1
Press MENU.
The main menu appears on the display panel.
P i c t u r e / S o u n d
P i c t u r e
A d j u s t P i c t u r e
A d j u s t S o u n d
, t o s e l e c t ,
e n t e r a d j .
2
Press M/m to move the cursor (yellow) to "Input
Select" and press ENTER.
Input Select menu appear on the display panel.
I n p u t S e l e c t
I N P U T 1 ( R G B )
I N P U T 1 ( C O M P O N E N T )
I N P U T 2 ( R G B )
I N P U T 2 ( C O M P O N E N T )
V I D E O ( C O M P O S I T E )
V I D E O ( Y / C )
, t o s e l e c t ,
t o e x e c u t e
3
Press M/m to move the cursor (yellow) to the
input source to be displayed and press ENTER.
INPUT1 (RGB): Selects the audio and video
signal input from the INPUT1 connectors
when the input signal is an RGB signal.
INPUT1 (COMPONENT): Selects the audio and
video signal input from the INPUT1
connectors when the input signal is a
component signal.
24
(GB)
C o n t r o l
M o d e : S t a n d a r d
, t o
ENTER
m e n u
p r e s s
ENTER
INPUT2 (RGB): Selects the audio and video
signal input from the INPUT2 connectors
when the input signal is an RGB signal.
INPUT2 (COMPONENT): Selects the audio and
video signal input from the INPUT2
connectors when the input signal is a
component signal.
VIDEO (COMPOSITE): Selects the audio and
video signal input from the COMPOSITE
IN connector and AUDIO IN jack among
the VIDEO connectors.
VIDEO (Y/C): Selects the audio and video signal
input from the Y/C IN connector and
AUDIO IN jack among the VIDEO
connectors.
The selected input signal appears on the display
panel.
Color system or horizontal/vertical frequency
S t a n d a r d
Picture mode
You can switch the input signal using the Remote
Commander supplied with your display panel.
Note
We recommend input source video equipment
equipped with a TBC (time base corrector). If the
display receives a signal without TBC, the picture
may disappear due to disturbance of the sync signal.
Signal type
I N P U T 1 ( R G B )
1 0 2 4 7 6 8 / 6 0