Connections In "Dmx" Mode; Connections In "Master / Slave" Mode; Stand-Alone-Operation - involight Paint BAR HEX12 Bedienungsanleitung

3.4 Connections in "DMX" mode:

DMX is the abbreviation for digital multiplex and allows the digital control of several DMX devices via a common
control cable.
Connect the DMX input of the unit to the DMX output of a DMX controller or other DMX device.
Connect the output of the first DMX device to the input of the second and so on to form a series circuit DMX
connectors: A three-pin XLR socket serves as a DMX output, a three-pin XLR connector serves as a DMX input.
For installations with very long DMX cable paths or high electrical interference, such as in a discotheque, it is
recommended to use a DMX terminator. The DMX terminator is connected in an XLR connector as a 120 Ω
resistor between pins 2 and 3 which is plugged into the last output socket of the DMX line.

3.5 Connections in "Master / Slave" mode:

When you configure a group of devices in "Master / Slave" mode, the first device controls the others and allows an
automatic or music-controlled and synchronized show. This feature is especially useful for starting a show without
great Programing. Connect the DMX output of the master device to the DMX input of the first slave device. Then
connect the DMX output of the first slave device to the DMX input of the second slave device and so on.

3.6 Stand-Alone-Operation:

The "PaintBAR HEX12" can also be used in stand-alone mode without a DMX controller. Disconnect the
"PaintBAR HEX12" from the controller and call the preProgramed program.
25