Daily Use; Setting And Starting A Programme - Electrolux GA55SLICN Benutzerinformation

16 www.electrolux.com
4. Close the lid. Make sure that the lid
locks into position.

9. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent (gel, powder or
tablets) in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
B
C
Fill the rinse aid dispenser
when the indicator (A) is
clear.
For information about the
detergent dosage, refer to
the manufacturer's
instructions on the
packaging of the product.
Usually, 20 - 25 ml of gel
detergent is adequate for
washing a load with normal
soil.
The upper ends of the two
vertical ribs inside the
compartment (B) indicate
the maximum level for filling
the dispenser with gel (max.
30ml).
9.2 Setting and starting a
programme
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press repeatedly until the
indicator of the desired programme is
on.
The display shows the programme
duration.
4. Set applicable options if desired.
5. Press to start the programme.
• The indicator of the running phase
is on.
• The programme duration counts
down in minutes.
Starting a programme with
delay start
1. Set a programme.