2 Your microwave oven
2.3 Installing the turntable
• Never place the glass tray upside down. The
glass tray should never be restricted.
• Both glass tray and turntable support must al-
ways be used during cooking.
• All food and containers of food must always
place on the glass tray for cooking.
• If glass tray or turntable support crack or break,
contact your nearest authorized service center.
3 Installation and connection
3.1 Installation and
connection
• Remove all packing material and accessories.
Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
• Remove any protective film found on the micro-
wave oven cabinet surface.
• Do not remove the light brown Mica cover that
is attached to the oven cavity to protect the
magnetron.
• Select a flat surface that provides sufficient
space for inlet and outlet ducts.
30cm
20cm
20cm
20cm
min85cm
• Minimum installation height is 85 cm.
Microwave Oven / User Manual
Göbek (alt kısım)
Hub (underside)
Glass tray
Cam tabla
Turntable shaft
Döner tabla mili
• Rear surface of the appliance should not be
placed against a wall. Leave a clearance of min.
30 cm above the oven; the minimum distance
between the oven and adjacent walls, if any,
should be 20 cm.
• Do not remove the spacers beneath the oven.
• Obstructing the inlet and outlet openings may
damage the oven.
• The appliance is fitted with a plug and must only
be connected to a properly installed grounded
socket.
• The mains voltage must correspond to the vol-
tage specified on the rating plate.
• If the plug is no longer accessible after instal-
lation, an all-pole isolating switch must be pre-
sent on the installation side with a contact gap
of at least 3 mm.
• Adapters, multi-way sockets and extension
cords must not be used. Overloading can result
with a risk of fire.
WARNING: Do not place the oven
onto a hob or any other appliance
A
that emits heat. Placing the oven
on or close to a heat resource may
damage the oven and consequently,
the warranty will become void.
Turntable support
Döner tabla desteği
11 / EN