Herunterladen Inhalt Inhalt Diese Seite drucken

Fitness; Troubleshooting; The Heart Rate Is Not Shown Or Is Shown Incorrectly; The Display Is Unreadable / The Light Does Not Work - Crivit 1-LD3945 Bedienungsanleitung

Herzfrequenz-messuhr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Fitness

FITNESS
FITNESS
LEVEL
LEVEL
After your training, immediately press SET. A 5 minute countdown will start (cool
down phase). The bar will show the remaining time. On the left side of the display
the heart rate at the beginning of cool down is shown. On the right side of the
display the current heart rate is shown. The countdown time is shown on the bottom
row of the display.
After 5 minutes your fitness level will appear.
Fitness level
Heart rate
6
>130
5
130-120
4
120-110
3
110-105
2
105-100
1
<100

Troubleshooting

The heart rate is not shown or is shown incorrectly

Make sure the chest belt is positioned correctly and fits well.
Your skin should not be too dry or too cold.
The contact areas can be slightly moistened to improve function.
Electromagnetic interference may have an adverse effect on reception.
The distance between watch and chest belt must be under 70cm.
Other heart rate measuring devices within a 2m range may also cause
interference.
Wireless bicycle computers may cause interference.
The batteries may be low and require replacing.

The display is unreadable / the light does not work

Replace the batteries.
- 17 -
NIV FORM
NIVEL
PHYSIQ
FIT

Replacing the batteries

Replacing the watch battery

The battery replacement can be performed by a watch maker in addition to a
water resistance test.
To replace the battery yourself, please read the following instructions first:
Remove the screws (1, 2, 3 and 4) from the back side of the watch with a small
Phillips screwdriver. Remove the caseback and the battery sticker.
Use a small, flat tool to open the latch (5) of the battery holder. Remove the
battery and insert a fresh 3V CR2032 battery with the (+) terminal facing upwards.
Ensure that the gasket (6) is seated correctly. Close the latch of the battery holder.
Replace the battery sticker and the caseback and replace the screws.

Battery low indicator

If the battery voltage on the chest belt battery drops below the voltage required for
normal operation,
TXBELT
TXGURT
LO BAT
BATT
will appear on the display. Replace the battery of the chest belt.
- 18 -
SNGLTX
TXBCIN
PILE
BAT BA

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 107990

Inhaltsverzeichnis