Care And Maintenance; Checking And Cleaning Door Seals . En; Cleaning The Exterior; Cleaning The Reverse Side - hanseatic HFD18983EI Gebrauchsanleitung

Page EN-22

Care and maintenance

Care and maintenance
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Before cleaning, unplug the mains
plug from the socket or isolate/un-
screw the fuse.
■ When pulling out the mains plug, al-
ways take hold of the mains plug it-
self and never the mains cord.
CAUTION
Hazards for children and people with
limited physical, sensory or mental ca-
pacity.
■ Cleaning and user maintenance must
not be carried out by children unless
they are supervised.
NOTICE
The surfaces and appliance parts can be
damaged through improper handling.
■ Never use harsh, granular, soda, acid,
solvent-based or abrasive cleaners.
These attack the plastic surfaces.
All-purpose cleaners with a neutral
pH are recommended.
■ Door seals and plastic parts are sen-
sitive to oil and grease. Remove con-
taminants as quickly as possible.
■ Only use soft cloths.
Checking and cleaning door
seals
The door seals must be checked regularly so
that no air can enter the appliance.
1. To test them, clamp a thin piece of paper
in various places. The paper should be
difficult to pull through at all points.
2. If the seal is not uniform everywhere:
Warm the seal in the appropriate places
in front of you with a hair dryer and pull it
out with your fingers.
3. Only clean dirty seals with clean water.

Cleaning the exterior

– Painted surfaces
Use only light pH-neutral soapy water.
– Stainless steel surfaces
Use special stainless steel cleaner from a
specialist shop. Never use polish.

Cleaning the reverse side

• Use a soft hand brush to carefully brush
the reverse side of the appliance once or
twice a year.
Defrosting and cleaning the
freezer
CAUTION
Danger of explosion!
Improper handling of the appliance
can lead to deflagration or explosion!
■ Never use defrosting sprays. They can
generate explosive gases.
■ Do not use any means other than
those recommended by the manufac-
turer to speed up defrosting. For ex-