Starting The Programme; Progress Of Programme - Beko WITV 8712 XW0R Bedienungsanleitung

4.3.11 End Time Adjustment
The End Time Adjustment function allows you to
set the end time of the programme up to 19 hours.
You can increase this time by 1-hour intervals.
C
INFORMATION
• Please do not use liquid detergent if you
have selected the End Time Adjustment
function. Stains might remain on the clothes.
1. Open the loading door, place the laundry
and add detergent, etc.
2. Select the washing programme,
temperature, spin speed and, if required,
the auxiliary functions.
3. Press the End Time Adjustment button and
select the desired time.
4. Press the Start/Pause button. The delayed end
time you have set will be displayed. Countdown
will start for delayed end. On the display, "_" will
move up and down next to the delayed end time.
C
INFORMATION
• If the programme has not started,
you can add laundry into the machine
during the delayed end time.
5. At the end of the countdown, duration of
the selected programme will be displayed.
"_" will disappear and the selected
programme will start.
Changing the delayed end time
If you want to change the time during countdown:
Turn the programme selection knob to cancel the
delayed end time function, and then set the desired
time again.
1. Press the End Time Adjustment button. When
pressed for the first time, the programme
duration will be rounded up to the closest
whole number time. Each following press will
increase the time by an hour.
2. If you want to decrease the delayed end
time, press the End Time Adjustment button
consecutively until the desired time is displayed.
Cancelling the delayed end function
If you want to cancel the delayed end time
countdown and start the programme immediately:
1. Set the Programme Selection knob to any
programme. This way, the Delayed End time
will be cancelled. The End/Cancel light will
flash continuously.
19 / EN
2. Then, select the programme you want to run
again.
3. Press Start/Pause button to start the programme.

4.3.12 Starting the programme

1. Press Start/Pause button to start the programme.
2. Programme follow-up light showing the
startup of the programme will turn on.
C
INFORMATION
• If no programme is started or no key is
pressed within 10 minutes during the
programme selection process, the display
lights will go off. Once the Programme
Selection knob is turned or any button is
pressed, display lights will turn on again.

4.3.13 Progress of programme

Progress of a running programme can be
followed from the Programme Follow-up
indicator. At the beginning of each programme
step, the relevant indicator light will turn on.
C
INFORMATION
• If the "Anti-crease+" auxiliary function
has been selected, "End" LED and "Anti-
crease+" LED will be on at the same
time while this step is continuing.
• To end the programme while the "Anti-
crease+" step is running, simply press any
button or turn the programme selection knob.
You can change the auxiliary functions, speed
and temperature settings without stopping the
programme flow while the programme is running.
To do this, the change you are going to make
must be something that will be carried out after
the programme step that is running. If the change
is not suitable, relevant lights will flash 3 times.
C
INFORMATION
• If the machine does not proceed to the
spinning step, the Rinse Hold function
might be active or the automatic
unbalanced load detection system might
be activated due to the unbalanced
distribution of the laundry in the machine.
Washing Machine / User Manual