Betriebsanleitung; Einschalten Des Geräts; Ausschalten Des Geräts; Turning The Appliance Off - Bromic Heating TUNGSTEN SMART-HEAT Installationsanleitung

BETRIEBSANLEITUNG

TURNING THE APPLIANCE ON
1. Ensure that installation has been carried out in accordance
with the manufacturers instructions outlined in this document.
2. Test the spark ignite button is working correctly by pressing the
button and observing sparks at the ignition rods at the front of the
heater. If sparks are not observed do not proceed with turning appli-
ance on. Contact the store of purchase for assistance and advice.
3. Turn ON the gas supply at the LPG storage bottle.
5. Continue to hold in the controls for 10 seconds.

TURNING THE APPLIANCE OFF

1. Press and turn the control knob to "OFF" position to stop the supply
of gas to the burner. The tiles should change colour from red to black.
WARNING
!
Do not turn the heater on with people standing in front of heater.
Heater must be turned on while standing behind the heater.
WARNING
!
Improper lighting procedures can cause personal injury, property
damage, or even death.
4. Press and turn the control knob to"IGNITION" position whilst
simultaneously pressing the spark ignite button.
6. Release the controls. If the heater has not ignited wait 5
minutes and then repeat Step 4.
7. After heater has ignited, the control knob must be turned
from "IGNITION" to "HI". When appliance is correctly ignited
the tiles will start to glow red.
2. Turn OFF the gas supply at the LPG storage bottle.
3. WARNING - After turning heater o , you must wait a minimum 5
minutes to let excess gas dissipate before lighting again.
www.bromicheating.com.au
21