Blaupunkt 5GB 62190 Montage- Und Gebrauchsanweisungen Seite 32

How to Use the appliance
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each burner, which is designed
to stop the flow of gas to the burner head in the event of the flame going out.
To ignite a burner:
o Press in the control knob of the burner that you wish to light and turn it anti-clockwise
to the maximum position.
o If you keep the control knob depressed, the automatic ignition for the burner will
operate.
o You should hold down the control knob for 15 seconds after the flame on the burner
has lit. If after 15s the burner has not lit, stop operating the device and open the
compartment door and/or wait at least 1 min before attempting a further ignition of the
burner.
o After this 15-second interval, to regulate the flame you should continue turning the
control knob anti-clockwise until the flame is at a suitable level. The operating position
MUST be at a position between the maximum and minimum position.
o To switch the burner off, turn the control knob fully clockwise to the gas off position.
o In case of power failure, the burners can be lit by carefully using a match.
32