Parameter / Register - Märklin E 10.12 Bedienungsanleitung

CV Discription
01 Address
02 PoM Minimum Speed
03 PoM Acceleration delay
04 PoM Braking delay
05 PoM Maximum speed
08 Factory Reset / Manufacturer Recognition
13 PoM Functions F1 - F8 in analog operation
14 PoM Functions F9 - F15 and lights in analog operation
17 Extended address (upper part CV29 Bit 5 = 1)
18 Extended address (lower part CV29 Bit 5 = 1)
19 Multiple Unit Address
21 PoM Functions F1 - F8 on Multiple Unit
22 PoM Functions F9 - F15 and lights on Multiple Unit
Bit 0: Reversing direction
Bit 1: Number of speed levels 14 or 28/128
29
Bit 2: DCC operation with braking area
Bit 5: Address length 7 Bit / 14 Bit
63 Volume
( ) Values = factory settings
DCC: programming on the programming track by means of CV programming,
programming with PoM (Program on the Main); this must be
supported by the controller you are using.
* The values for the desired setting must be added!
Example: The number of speed levels 28/128 = 2 + DCC operation with a braking route = 4, results in the value = 6
6021 Value DCC Value
01 - 80 (72)
CV 29/Bit 5 =0
—
01 - 63
01 - 63
01 - 63
08
—
—
— 192 - 255 (192)
—
—
—
—
—
01 - 63 (63)
11
Betrieb • Operation • Fonctionnement • Exploitatie
1 - 127 (3)
0 - 255 (20)
0 - 255 (15)
0 - 255 (15)
0 - 255 (206)
08 (131)
0 - 255 (1)
0 - 255 (1)
0 - 255 (128)
0 - 255 (0)
0 - 255 (0)
0 - 255 (0)
0 / 1 (0)*
0 / 2 (2)*
0 / 4 (4)*
0 / 32 (0)*
0 - 255 (255)