Step 4 - Rear Basket Tube Assembly - Foundations LX3 Bedienungsanleitung

STEP 3 - Front Wheel Assembly (continued)
5.
While holding bearing on front wheel post, position
Front Wheel Assembly (D) so bearing race (Z) is
facing front wheel post (X) and bearing (Y) inside Front
Wheel Assembly is on opposite side, slide Front Wheel
Assembly onto front wheel post and bearing
(Fig. 3).
6.
Slide Lock Washer (L) and Flat Washer
(M) onto M6 x 25 mm Shoulder Screw (K)
and then insert screw into bottom of front
wheel post and tighten securely (Fig. 4).
Repeat steps 2 thru 6 to assemble
front wheel on other side of stroller.
1.
Position Rear Basket Tube (G) with curved
bend (W) pointing down (Fig. 1).
2.
Secure the Rear Basket Tube onto the stroller by
sliding the ends of the Rear Basket Tube onto the
tubes at the side of the stroller frame until the ends
contact the spring buttons (Fig. 1).
3.
Press the spring buttons
Tube onto the tubes
into the holes in the Rear Basket Tube (Fig. 2).
4.
Pull out on the Rear Basket Tube to check that
it is securely attached
5.
Attach fabric basket to Rear Basket Tube.
- Unsnap snaps (X) on fabric basket (Y), wrap fabric
basket over the top of the basket tube (Z) and
reattach snaps on fabric basket (Fig. 3).

STEP 4 - Rear Basket Tube Assembly

1 and slide the Rear Basket
until the spring buttons lock
2
(Fig. 2).
3
L
K
G
W
7
Z
M
3
X
Y
Z
Fig. 3
Y
Fig. 4
Fig. 1
Fig. 2
2
1
Fig. 3