Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing the lens
Replacing the lens on the models such as VPL-V500Q/QM, W400Q/QM
1
Turn off the MAIN POWER switch of the projector.
2
Remove the four screws (3 x 8 mm) on the top panel with
a Phillips-head screw driver.
3
Disconnect the connector of cable (1 plug) running
between the top panel and the circuit board C of the
projector and remove the top panel.
4
Remove the shield case lid.
Remove the cable harness and remove all the plugs from
their connectors in the circuit board (7 plugs in the VPL-
V500Q/QM; 8 plugs in the VPL-W400Q/QM). Also
remove the three LCD panel flexible cables from their
connectors.
Connectors
(1 for each
place)
Connector
(W400Q/QM only)
Note
Do not touch a tip of the felxible cable.
Connector (1)
Shield case lid
Flexible cables
(3)
Cable harness
Connectors (3)
Connector (2)
17
Werbung
Inhaltsverzeichnis
