Lamp Control; Personality - Futurelight PHS-1200E Pro-Head-Spot Bedienungsanleitung

Lamp Control

Lamp on or off
With this function you can switch the lamp on or off via the Control Board.
• Select "Lamp on or off" by turning the encoder.
• Press the enter-button, the display shows "ON" or "OFF".
• Turn the encoder to select "ON" if you wish to strike the lamp or "OFF" in order to switch it off.
• Press the enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Lamp on by power on
With this function you can select if the lamp will be switched on when switching the power on. Select "ON"
by turning the encoder if you wish to enable this function or "OFF" if you don't.
Lamp on via external controller
With this function you can select if you can switch the lamp on via an external controller (DMX-channel 24,
value 64-79). Select "ON" by turning the encoder if you wish to enable this function or "OFF" if you don't.
Lamp off via external controller
With this function you can select if you can switch the lamp off via an external controller (DMX-channel 24,
value 224-239). Select "ON" by turning the encoder if you wish to enable this function or "OFF" if you don't.
Lamp off if no DMX
With this function you can select to switch off the lamp off automatically if there is no DMX signal.
Lamp on at temp.
With this function you can set the inside temperature from which the projector will restrike the lamp after
automatic lamp shutoff.
Lamp off at temp.
With this function you can set the inside temperature at which the projector will automatically switch the lamp
off. Turn the encoder to select the maximum inside temperature between 80° C and 139° C. Inside
temperatures below 90° C are not critical. 90° C and more should lead to the lamp being switched off. Please
note that the outside temperature should not exceed 45° C.

Personality

Status settings
Blackout moving
With this function, you can switch the DMX-function Blackout with Pan/Tilt-movement (DMX-channel 3,
values 226-235) on or off.
Blackout colors/gobos
With this function, you can switch the DMX-function Blackout at colour/gobo-change (DMX-channel 3, values
236-245) on or off.
Addr. via DMX
With this function, you can adjust the desired DMX-address via an external controller.
• Select "Addr. via DMX" by turning the encoder.
• Press the enter-button, the display shows "ON" or "OFF".
• Turn the encoder to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press the enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address between 1
and 255. When set to "8" you can adjust the starting address between 256 and 511.
• Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting address to
57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the starting address to 420,
set channel 1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is set.
59/130 00026924.DOC; Version 1.6