Troubleshooting; Troubleshooting Table - Inventum IVW6040AXL Benutzerhandbuch

RINSE AID CONSUMPTION SETTINGS
Level Number of rinse aid doses that is dispensed
1 Rinse aid not dispensed
2 1 dose
3 2 doses
4 3 doses
5 4 doses
8

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.

TROUBLESHOOTING TABLE

Problem
The program does not start.
A function indicator is on and the
display goes on and off.
The ready indicator does not go off
when a program is finished.
The detergent reservoir contains
detergent residues.
The appliance contains water when
the program is finished.
The appliance stops during a
program.
50 • English
Possible cause
The mains plug is not connected.
There is a problem with the fuse.
There is no water supply.
The door of the appliance is open.
The appliance is switched off.
The water inlet hose and filters are
clogged.
The door is open.
The on/off button is pushed.
The detergent reservoir is filled while
the reservoir was still damp.
The drain hose is clogged or twisted. •
The filters are clogged.
The program has not finished.
There is a power failure.
There is a water inlet failure.
Display indicator
r1
r2
r3
r4
r5
'Resetting the program'
Possible solution
Connect the mains plug.
Do a check on the fuse box.
Open the water tap.
Close the door.
Start the appliance. Refer to section
'Starting the appliance'
Make sure that the water inlet hose
and the filters are not clogged.
Close the door.
Release the on/off button.
Make sure that you fill the detergent
reservoir when it is dry.
Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
Clean the filters. Refer to section
'Cleaning the filters'
Wait until the program is finished.
A buzzer sounds five times and the
ready indicator is on when a program
is finished.
Make sure that there is power.
Make sure that there is water inlet
supply.
.
.
.