placed as soon as any wear is noticed. Daily: Clean
the tool holder.
- Inspect the mounting screws: Regularly inspect all
the mounting screws and ensure they are firmly tight-
ened. Should any screw be loose, tighten it immedi-
ately. Failure to do so could put you at serious risk.
- Motor maintenance: Take the utmost care to ensure
that the motor winding is not damaged and does not
become damp with oil or water.
- Brush replacement: The brushes disconnect auto-
matically and should be replaced after 150 - 200 hours
use or when they are less than 10 mm long. Have
them replaced by an Official Service Centre.
- Clean the machine thoroughly after each use with a
blast of dry air.
- The vents of the machine should be kept clear at all
times.
- Check that the mains lead is in good condition. If it is
not, take it to an Official Service Centre to have it re-
placed.
- Use only Felisatti accessories and spares. The parts the
changing of which is not covered in this instruction man-
ual, should be replaced in a Felisatti Official Service Cen-
tre (See Warranty Official Service address leaflet).
Do not dispose of electric tools in
the household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.
WARRANTY
See general warranty conditions printed on the attached
sheet.
DECLARATION OF CONFORMITY
We hereby declare, under our own responsibility,
the FELISATTI products described in this manual
RHF45/1000VET and RHF50/1200VERT comply
with the following standards or standard docu-
ments EN60745-1:2008, EN60745-2-6, EN55014-
1:2006+A1, EN55014-2:1997+A1+A2, EN61000-
3-2:2006+A1+A2 and EN61000-3-3:2008 and in
accordance with EU Directives 2006/42/EC,
2006/95/EC, 2004/108/EC and 2002/95/EC.
11
We reserve the right to make technical changes 09/2011
Francisco Ruiz
Plant Mgr.