JUNO JGVX60528 Benutzerinformation Seite 20

20
Problem
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry water
drops on glasses and dishes.
The dishes are wet.
The interior of the appliance is
wet.
Unusual foam during washing.
Traces of rust on cutlery.
There are residues of deter‐
gent in the dispenser at the
end of the programme.
Odours inside the appliance.
All manuals and user guides at all-guides.com
Possible cause and solution
• Tableware has been left for too long inside the closed
appliance.
• There is no rinse aid or the dosage of rinse aid is not
sufficient. Adjust the rinse aid level to a higher level.
• Plastic items may need to be towel dried.
• For the best drying performance, activate XtraDry and
AirDry.
• We recommend to always use rinse aid, even in combi‐
nation with multi-tablets.
• The released quantity of rinse aid is too high. Adjust the
rinse aid level to a lower level.
• The quantity of detergent is too high.
• The released quantity of rinse aid is not sufficient. Adjust
the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
• For the best drying performance, activate XtraDry and
AirDry .
• The programme does not have a drying phase or has a
drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
• This is not a defect of the appliance. Humid air conden‐
sates on the appliance walls.
• Use the detergent designed specifically for dishwashers.
• There is a leak in the rinse aid dispenser. Contact an
Authorised Service Centre.
• There is too much salt in the water used for washing.
Refer to "The water softener".
• Silver and stainless steel cutlery were placed together.
Avoid putting silver and stainless steel items close to‐
gether.
• The detergent tablet got stuck in the dispenser and was
not completely washed away by water.
• Water cannot wash away the detergent from the dis‐
penser. Make sure that the spray arm is not blocked or
clogged.
• Make sure that items in the baskets do not impede the
lid of the detergent dispenser from opening.
• Refer to "Internal cleaning".