Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500
W, we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor size
2
is 1.5 mm
. When using a cable reel, always unwind
the cable completely. Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
17
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Assembly and adjustment
DW563/DW563KC - Selecting the operating
mode (fig. B)
The Rotary Hammer Drill can be used in two
operating modes:
.
DW566K/DW566KC - Selecting the operating
mode (fig. B)
The Rotary Hammer Drill can be used in three
operating modes:
60
• Select the required operating mode by rotating
the mode selector (4) towards the symbol on the
6
10
gear housing.
15
• For screwdriving, refer to section "Instructions for
20
use".
25
-
Inserting and removing SDS-plus
-
-
6
6
(fig. C)
Your Rotary Hammer Drill uses SDS-plus
6
6
accessories (refer to the inset in fig. C for a cross-
15
section of an SDS-plus
15
• Clean and grease the bit shank.
20
• Insert the bit shank into the tool holder (8).
-
Prior to assembly and adjustment always
unplug the tool.
Rotary drilling:
for screwdriving, drilling into steel, wood
and plastics
Hammer drilling:
simultaneous rotating and impacting for
concrete and masonry drilling
Rotary drilling:
for screwdriving, drilling into steel, wood
and plastics
Hammer drilling:
simultaneous rotating and impacting for
concrete and masonry drilling
Hammering only with spindle lock:
impacting only - for light chipping,
chiselling and demolition applications.
®
bit shank).
E N G L I S H
®
accessories
®
en - 4
Werbung
Kapitel
Inhaltsverzeichnis
