Peavey TransTube 100 EFX Handbuch Seite 41

Power Amplifier Section:
Power measured with T. Dynamics
(5% THD, 1 kHz, 120 VAC line)
Rated Power and Load:
65 W RMS into 8 Ohms
Frequency Response:
+3, -0 dB 100 Hz to 20 kHz @ 50 W RMS into 8 Ohms
Hum and Noise:
Greater than 90 dB below rated power
Power Consumption:
Domestic: 200 W @ 60 Hz, 120 VAC
Export: 200 W @ 50/60 Hz, 220-230 VAC
Preamp Section:
Preamp specs measured a 1 kHz with controls
preset as follows:
Channel Select - Clean
Clean Mode Switch - Modern
Low and High EQ - 10
Mid EQ - 0
Lead Pre and Post Gain - 10
Lead Mode Switch - Vintage
Effects - Off
Nominal Levels - Clean Volume @ 5
Minimum Levels - Clean Volume @ 10
Preamp High Gain Input:
Impedance: High Z, 250 k Ohms
Nominal Input Level: -12.6 dBV, 234 mV RMS
Minimum Input Level: -23 dBV, 70 mV RMS
Maximum Input Level: 0 dBV, 1 V RMS
112 EFX SPECIFICATIONS
@ 100%
®
Features and specifications subject to change without notice.
Effects Send:
Load Impedance: 1 k Ohms or greater
Nominal Output Level:
Effects Level: -8.4 dBV, 380 mV RMS
Effects Return:
Impedance: High Z, 22 k Ohms
Designed Input Level:
Effects Level: -8.4 dBV, 380 mV RMS
(Switching jack provides Effects Send to Effects
Return connection when not used.)
System Hum and Noise @ Nominal Input Level:
(20 Hz to 20 kHz unweighted)
Greater than 76 dB below rated power
Equalization:
Clean Channel:
Special Low, Mid, and High passive EQ
Modern/Vintage Switch: Two distinct EQ voicings
Lead Channel:
Low, Mid, and High passive EQ
Vintage/Modern/High Gain Switch: Three different EQ
and Gain voicings
Presence fixed: 2 dB @ 7 kHz
Resonance fixed: 3 dB @ resonant frequency of cabinet
External Footswitch Functions:
Channel select; effects control
Dimensions:
18" H x 21.5" W x 10.75" D
(457 mm H x 546 mm W x 273 mm D)
Weight:
34.5 lbs. (16 kg)
41