Energy Saving Tips - Burnhard Big Fred Handbuch

LEAK TEST
• Use a commercially available leak detection spray or paint brush and soapy water to check all
connections (mixing ratio of soap to water: 1:3).
• Open the gas cylinder valve. Bubbles will appear on all leaking points.
• Close the valve again.
• Tighten the nuts on both sides by hand again and repeat the leak test. If you still notice bubbles, clo-
se the gas valve and consult a specialist dealer.
Repeat the leak test every time you change the gas cylinder.

ENERGY SAVING TIPS

1. Turn the grill off as soon as you are done grilling.
2. Preheat the grill with the lid closed for only 10-15 minutes (except for the first use).
3. You do not need to preheat the grill longer than specified.
WARNUNG: Check the gas connections for breakages, wear, or tear before use. Should you
notice any of these, do not use the grill until the issue has been resolved.
When replacing or unscrewing the gas cylinder, make sure there are no fire sources such as candles,
electrical appliances, or cigarettes within reach. Always check to ensure the cylinder is properly closed.
42