Basic Operation; Learn More; Initial Setup - Kruger & Matz KM0240FHD-S5 Bedienungsanleitung

BASIC OPERATION

1. Connect the device to power supply socket.
2. Connect the antenna cable into the appropriate RF input.
Switch the TV on and off
1. When the TV is connected to power supply, it will be turned on directly or be in
standby mode (red LED is on). If the TV is in standby mode, press the Power
button to turn it on.
2. To put the TV set into standby mode, press the Power button on the TV set or
remote control. The TV set remains on, but with low energy consumption. To
switch off the TV set, unplug it from power supply.
Note: For some models, press Power button to switch off the TV set.

INITIAL SETUP

The first time you switch the TV set on, the Welcome screen appears, which guides
you through the initial setup process. Follow the on-screen instructions to finish the
initial setup process such as selecting the language, connecting to the network,
scanning channels and more. During each step, either make a choice or skip the
step. If you skip a step, you can perform the setup later from the settings menu.
LOCK CODE
To enable lock function, input default code 1234. Default code should be changed in
the lock menu. If you forget existing code, input code 0423 to access the lock menu.
20
Owner's manual Owner's manual

LEARN MORE

For more information on this device visit: www.krugermatz.com.
Visit www.krugermatz.com website for more products and accessories.
In case of any doubts or questions reach out to our Frequently Asked Questions section.
Lechpol Electronics Sp. z o.o. Sp.k. hereby declares that LED TV KM0240FHD-S5 is
consistent with directive 2014/53/UE. Full text of the EU Declaration of Conformity
is available at following Internet address: www.lechpol.pl
Radio Information
• 2.4G Wi-Fi transmitter frequency range: 2412 - 2472MHz
• 2.4G Wi-Fi transmitter power: 16dBm (+/- 4dB)
• DVB-T/T2/C tuner frequency range: 45 - 858MHz
• DVB-S/S2 tuner frequency range: 950 - 2150MHz
It is forbidden to place equipment waste marked with the symbol of a crossed-out trash bin
together with other waste. This equipment is subject to collection and recycling. The harmful
substances it contains can cause environmental pollution and pose a threat to human health.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.
Do not touch or be close to the ANT IN, SATELLITE IN, LAN port, AV IN, AV OUT,
HDMI input, USB 2.0 port and prevent electrostatic discharge to disturb these
terminals when in USB and LAN mode; otherwise it will cause the TV to stop
working or abnormal status.
English
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
21