Use - Casselin CAPF Bedienungsanleitung

power system data. Connect the device only when there is compliance. The unit should be unpacked and
EN
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be fully
withdrawn.
Do not install this device near open fires or other heating appliances.
BEFORE FIRST USE
Place the unit in a well ventilated area. Connect the grill, turn the thermostat dial to maximum and turn the
camera on. This will dry up any remaining moisture and will burn all factory sediments.
When the maximum temperature is reached, turn off the appliance, let it cool for about an hour.
Clean the grilling surface with a cleaning brush with a cleaning liquid and warm water. Rinse and dry
thoroughly.
Heat cast iron plate about 10 minutes until all the smoke and / or odor has dissipated. Rub the surface with
steel wool and detergent to remove the coating.
Unplug the unit, then use hot soapy water to clean.
NEVER USE COLD WATER ON THE HOT PLATE
USE
Plug the unit in a well ventilated area.
Pressing the ON / OFF switch and turn the thermostat to the desired temperature (280 ° C recommended).
Using a brush, spread of oil on the impressions of the plate.
The red light goes off when the temperature reached.
Pour batter over each footprint and cook.
To get the desired browning on the underside, turn the poffertjes with the picnic supplies.
At the end of the service, turn the thermostat to 0 and unplug the appliance.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.