52 electrolux
GB
cartridge in the funnel as described in
chapter "How to change the BRITA
MAXTRA cartridge".
How to use the BRITA MAXTRA
filter cartridge
STEP 1: PREPARING THE CARTRIDGE
To
prepare
your
cartridge, please remove protective
wrapper (note: cartridge and inside
wrapper may appear moist, this is
simply
condensation).
cartridge in cold water and shake it
gently to remove any air bubbles. The
filter now is ready to use. As required
for some other water filter cartridges,
there is no need to pre-soak the new
Maxtra Cartridge.
STEP 2: INSERT IN THE WATER TANK
Remove the tank lid. Before inserting
the cartridge, remove the funnel and
clean it thoroughly by rising it and
wiping it dry. Then thoroughly clean
the inside of the water tank with a
dump cloth and wipe it dry as well.
All manuals and user guides at all-guides.com
BRITA
filter
Immerse
Place the cartridge into the filter tank
and push downwards until it 'clicks'
firmly into place. The cartridge
should stay in place if the funnel is
turned upside down.
STEP 3: RINSE CARTRIDGE
Take the funnel out of the BRITA
water filter unit, fill it under the tap
with cold tap water and allow it to
filter through. Discard the first two
fillings into the sink.These first two
fillings are used to flush the filter
cartridge.
Then place the funnel back into
BRITA water filter unit.
Place the cover back onto the jag
and press it carefully downwards to
ensure it fits correctly into place.
STEP 4: REFILL WATER TANK
To fill the tank with cold water, simply
open the flip top lid, take a jug of tap
water and pour it inside the tank
through the cover as shown into the
picture (use the lid every time that
you want to filter your water).
Important!
In order to avoid risk of spillage of water
during closing and opening of the
refrigerator door, we recommend to not
fill completely the water tank but leave a
head space of air.
NOTE: IF YOU HAVE NOT USED ALL
FILTERED WATER IN THE WATER TANK