Controls; Lighting - Electrolux WHL6036CN Gebrauchsanleitung

www.electrolux.com
6

4. CONTROLS

The hood can be switched on pushing directly onto the requested speed without firstly having
to select 0/1 button.
Button
L
T1
T2
T3
T4
S1

5. LIGHTING

• For replacement contact techni-
cal support ("To purchase contact
technical support").
S1
L
Led Function
- Turns the lights on/off at maximum strength.
Fixed Turns the motor on/off at speed one.
Fixed Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds, with all the
loads turned off (Motor and Lights), to turn the Activated Charcoal Filter
alarm on. The relevant LED flashes twice to confirm.To turn the alarm
off, press the button again and hold for at least 3 seconds. The relevant
LED flashes once.
Fixed Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the lo-
ads turned off (Motor and Lights), to perform a reset of Filter saturation
alarm. The LED S1 flashes three times.
Fixed Turns the Motor on at INTENSIVE Speed.This speed is timed to run for
6 minutes. At the end of this time, the system returns automatically to
the speed that was set before. If it is activated with the motor turned off,
the hood will switch to OFF at the end of the time.
Press and hold for 3 seconds to enable the remote control, indicated
by the LED flashing twice.Press and hold for 3 seconds to disable the
remote control, indicated by the LED flashing just once.
Fixed Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood has
been in operation for 100 working hours.
Flashing When this is activated, it signals the Activated Charcoal Filter satura-
tion alarm, indicating that the filter must be changed; the Metal Grease
Filters must also be washed. The Activated Charcoal Filter saturation
alarm comes into operation after the Hood has been working for 200
hours.
T1 T2 T3 T4