Zanussi ZRG15805WA Benutzerinformation Seite 25

5. Unscrew and install the screw on the
opposite side.
6. Install the hinge on the opposite side.
7. Screw the right foot.
8. Unscrew the screws of the door top hinge.
9. Remove the hinge. Put over the pin in the
direction of the arrow. Install the hinge on
the opposite side.
1
3
10. Tighten the hinge.
www.zanussi.com
2
11. Put the top in position.
12. Push front the top.
13. Screw both screws on the rear side.
14. Remove and install the handle on the
opposite side.
1
3
2
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket.
In case you do not want to carry out
the above mentioned operations,
contact the nearest Authorised
Service Centre. The Authorised
Service specialist will carry out the
reversibility of the doors at your cost.
25