Mounting The Camera - D-Link DCS-936L Installationsanleitung

MOUNTING THE CAMERA

Please refer to the steps below to assist you with mounting the camera. It is recommended that you
configure the camera before mounting.
1
2
3
4
5
6
4
Step 1:
Hold the base of the camera with one hand placing your thumb on
the tab, then press down on the release buttons with your other hand
and pull the camera from the camera base.
Step 2:
Place the camera base where you want to position the camera and
use a pencil to mark the holes. Make sure that the cable channel on
the camera base is facing in the direction you want.
Step 3:
Depending on the material of the wall or ceiling, use proper tools to
drill two holes 25mm deep with a 6mm drill bit where you marked. If
the wall is made out of concrete, drill the holes first, then insert the
plastic anchors to support the screws.
Step 4:
Pull the power cable through the middle of the camera base and
through the cable channel as shown.
Step 5:
Place the camera base over the holes that are in the wall. Make sure
to align the camera base holes with the holes in the wall. Use the
supplied screws to attach the camera base to the surface of the wall.
Step 6:
Attach the camera to the camera base and pull the power cable to
remove the extra cable. Adjust the angle of the camera as desired.
DCS-936L