Panasonic CS-E24LKES Bedienungsanleitung Seite 3

WARNING WARNING
POWER SUPPLY
Do not use modifi ed cord,
joint cord, extension cord or
unspecifi ed cord to prevent
overheat and fi re.
Do not share the same power outlet with other
equipment to prevent overheat and fi re.
Do not operate with wet hands to prevent electric
shock.
If the supply cord is damage, it must be replaced
by the manufacturer, its service agent or similarly
qualifi ed persons in order to avoid a hazard.
Strongly recommended to be installed with Earth
Leakage Circuit Breaker (ELCB) or Residual
Current Device (RCD) to prevent electric shock
or fi re.
This equipment must be earthed to prevent
electrical shock or fi re.
In case of emergency or abnormal conditions
(burnt smell, etc), turn off the power supply, and
please consult authorized dealer.
Prevent electric shock by switch off the power
supply when:
- Before cleaning or servicing.
- Extended non-use.
- Abnormally strong lightning activity.
All manuals and user guides at all-guides.com
INDOOR UNIT AND OUTDOOR UNIT
REMOTE CONTROL
CAUTION CAUTION
Do not wash the indoor unit with water, benzene,
thinner or scouring powder.
Do not use for other purpose such as
preservation of food.
Do not use any combustible equipment in front of
the airfl ow outlet to avoid propagate fi re.
Do not expose directly to cold air for a long
period.
Do not sit or step on the unit, you may
fall down accidentally.
Do not touch the sharp aluminium fi n,
sharp parts may cause injury.
Do not switch ON the indoor when waxing the
fl oor. After waxing, aerate the room properly
before operating the unit.
Do not install the unit in oily and smoky areas.
Ensure drainage pipe is connected properly.
Otherwise, leakage may occur.
Aerate the room regularly.
After long period of use, make sure the
installation rack is not deteriorate to prevent the
unit falls down.
Do not use rechargeable (Ni-Cd) batteries.
It may damage the remote control.
Remove the batteries if the unit is not going to be
used for a long period of time.
New batteries of the same type must be inserted
following the polarity stated to prevent
malfunction of the remote control.
Indoor
Unit
Remote
Control
Air Outlet Air Outlet
Outdoor
Unit
Air inlet Air inlet
Air inlet Air inlet
Power
Supply
Air inlet Air inlet
Air Outlet Air Outlet
3