Panasonic KX-PRLA20E Installationsanleitung Seite 4

Installation
Note:
R The handset display may show "Please wait for 1 minute." when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold M
seconds to turn the handset on.
1
Handset:
Lift the handset and press M
2
Base unit:
Press and hold M
R If all registered handsets start ringing, press M
3
Handset:
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows "Please
4
With the handset still on the base unit or charger, wait until a confirmation tone
sounds and
Note:
R If an error tone sounds, or if
the base unit's operating instructions.
4
PRLA20E_PRLA20EX(en)_1007_ver0114
All manuals and user guides at all-guides.com
,
N for about 5 seconds.
this step.
wait for 1 minute.".
is displayed.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
4
1
) and the charge contacts with a dry cloth and
N.
N again to stop, then repeat
is displayed, register the handset according to
2
N for few
2014/10/07 15:34:59