Zanussi ZDF18001WA Benutzerinformation Seite 18

3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to "Setting and starting
a programme".
2. Press and hold, at the same time,
and
,
3. Press
.
• The indicators of
off.
• The indicator of
flash.
• The display shows the current setting of
the water softener, e.g.
4. Press
again and again to change
the setting. Each time you press the button
you select the next level.
18
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
until the indicators of
and start to flash.
and
continues to
= level 5.
Do not use detergent and do not load the
baskets.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
5. Deactivate the appliance to confirm the
setting.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
go
1
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
2
www.zanussi.com