Atag HI6071T Anleitung Seite 70

INSTALLATION
Install the appliance in such a way that the power plug remais
accessible always.
1. Check if the kitchen cabinet and the cut out are in accordance
with the instructions (see 'safety' and 'building in dimensions').
2. Remove the protective foil of the sealing strip (A) and attach the
sealing strip in the groove of the aluminium profiles or the edge of
the glass plate. Do not attach the sealing strip through the corner.
Instead, cut 4 pieces that fit tightly together in the corners.
3. If the woodtop is made of treated wood, then coat the sawn
surfaces of the top with sealing varnish, to prevent moisture
causing the top to swell.
4. Turn the appliance over and put it in the cutout.
5. Connect the appliance to the electricity supply. The displays will
illuminate and in the timer display the text "Co" will appear. The
displays will extinguish after a short time.
6. Check its operation. If the appliance has been connected
incorrectly, it will emit a beep signal or the displays will not
illuminate.
7. Hand over the instructions to your customer.
Immediately after switching on the fan will start. The appliance will
now carry out a self-check for a few seconds.
138
building in
min.
560 x 6 mm
48
50
200
A