Operation; Switching On And Power Setting; Switching Off - ETNA T303ZT Bedienungsanleitung

OPERATION

Switching on and power setting

Switching off

EN 8
The power can be set to 9 different levels. The hob also has a 'boost'
setting which is indicated by a 'P' on the display (see 'Boost'). The front
left cooking zone has a 'Power Boost' (SP).
• Place the pan in the middle of a cooking zone.
• Press the On/Off button (A).
You will hear a single beep and a '0' will appear in the display (B)
next to each cooking zone. If you don't do anything else, the
cooking zone will switch off automatically after 10 seconds.
• Press the on/off button (C) for the cooking zone concerned.
The '0' next to the selected cooking zone will light up clearly.
• Using the – and + buttons (E) select the preferred power level.
When you select the – button directly, the cooking zone will be
switched on at power level 9.
The set power is visible in the display (B).
Please note! All 4 zones cannot be set to level 9 (or P) at the same time
if the appliance is connected to 1 phase. The 4 zones can be set to a
maximum level 7 at the same time. Another zone needs to be reduced
or switched off if a higher level is desired. The appliance will beep and
the set power level in the display will start to flash. You should then set
the zones to a lower level!
Switching off one cooking zone
One cooking zone is switched on. The display shows a power level
between 1 and 9, or "P".
• Press the button (C) for the cooking zone to be switched off. Set
the cooking zone to '0' with the – button (E).
The cooking zone switches off
The hob switches off after 20 seconds, if all cooking zones are set
to '0' and no other process is being used.
Switching off all cooking zones
Several cooking zones are active.
• Press the On/Off button (A) to switch off all cooking zones.
You will hear a beep. All displays are off. The hob is switched off.