Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Getting Started
Installing the Product
You can install your product on a stand or hang it on the wall. When installing the product, please make
sure that enough space is left to insert a disc. If you do not, product will not operate normally.
Installation Precautions
• If you install your product on a wall, the wall must be flat and vertical.
• Avoid installing the product in areas with high temperature or humidity, or on a wall that cannot sustain the weight of the
set.
• Check the strength of the wall. If the strength of the wall is insufficient to support the product, make sure to reinforce the
wall before installing.
• Check the compostion of the wall. If the wall is made of plaster board, marble, or iron board, purchase and use the
appropriate mollies and fixing screws.
• Connect all cables from external devices (TV, etc.) to the product before you install it.
• If you are installing the product onto plasterboard (dry wall), we recommend locating a stud behind the wall and screwing
the support screws into the stud.
• To prevent electric shock, be sure to turn off the product before you install it.
• Do not hang on the installed product and avoid hitting it.
• Secure the unit firmly to the wall so that it does not fall off. If the unit falls off, it may result in injury or in damage to the
product.
• If you install the product on a wall, please make sure that a child does not pull any of connecting cables, as it may cause
the product to fall.
Case 1 : Installing on the Stand
To install on the Stand, insert the Stand Holder into the bottom slot of the product.
Case 2 : Installing on a Wall
1. Insert the Bracket-Set into the back slot of the Blu-ray Disc product. Insert the two screws as shown
below, and then turn them clockwise to secure it.
16
|
English
HT-ES8200_XU_0425.indd 16
HT-ES8200_XU_0425.indd 16
2012-04-25 오전 11:14:14
2012-04-25 오전 11:14:14
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
