Description; Installation; Overhead Rigging - EuroLite LED PAR-64 Bedienungsanleitung

Leaking or damaged batteries can cause irritations when getting into contact with the skin. In this case use
appropriate protective gloves.
Make sure that the battery cannot be short-circuited, thrown into the fire and be charged. There is a danger
of explosion.

DESCRIPTION

High Power LED RGB Outdoor Spot!
• Control via optional IR remote or any regular 512-DMX-controller
• Ideal LED-luminary for outdoor use
• Locking possibility at the mounting bracket
• Perfect for public places and buildings
• 145 High-power 10mm LEDs
• Advantages of high-power LED-technology: extreme light output, extremely long life, low power
consumption, defacto maintenance free
• Ready for connection with power cord and safety power plug
• Available in 20° or in 40° versions of the LED beam angle

INSTALLATION

Overhead rigging

The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The projector has to be installed out of the reach of people.
16/39 51914100_V_1_0.DOC