Atag WS9074MG Gebrauchsanweisung Seite 134

Wi-Fi-connectivity
First steps to set up the Wi-Fi connectivity:
Within the following steps, the "Connection setup" is performed:
INFORMATION!
Troubleshoot quickly by turning the Wi-Fi module off and on again. You can find more help in the
"Wi-Fi troubleshooting" section.
Depending on the Wi-Fi state, there are 1 to 3 options available in the menu:
The Connection Setup Mode
The Pairing Mode
Remote control mode
If more than 1 option is available then use the + (plus) and - (minus) keys to toggle between the
options.
Connection Setup Mode
The appliance must be connected to the Cloud for the application to monitor and control the appliance
remotely.
'C' is shown on the display. Touch the timer key to enable 'Connection Setup Mode'. The Wi-Fi symbol
will flash. This mode will be disabled automatically after 5 minutes.
Pairing Mode
By pairing, you gain monitoring functionality inside the ConnectLife-app. During pairing, you connect
your appliance to your ConnectLife user account.
Pairing Mode is only available if the Wi-Fi connectivity setup has been performed.
14
1. Check the "Requirements" as described above.
2. The hood and lights must be switched off.
3. Touch and hold simultaneously the – (minus) and timer key for
3 seconds to enter the Wi-Fi menu. The 'Light' icon will be turned
off.
4. Touch and hold simultaneously the – (minus) and timer key for
3 seconds to turn on Wi-Fi. 'o' will blink 3 times. Wi-Fi symbol will
blink.
5. Touch and hold simultaneously the + (plus) and timer key for
3 seconds. The display will show an 'C'. Confirm with the timer key
to start the 'Connection menu'. This mode will be disabled
automatically after 5 minutes.
6. In the ConnectLife-app, select the option 'Add Appliance' and follow
the instructions.
7. If the ConnectLife-app does not connect to the device, wait
10 minutes and repeat the steps described.
8. Optionally: When the process was successful, and you want to pair
another user, you can use the 'Pairing mode' of the Wi-Fi menu and
the 'Pairing' or 'Discovery' option of the ConnectLife-app.