Operation; Specifications - Ryobi LSDT1202 Bedienungsanleitung

GB
FR DE ES
DESCRIPTION
1. Keyless chuck
2. Switch trigger
3. Bit storage
4. Rotation selector (forward/reverse)
5. Torque adjustment ring
6. Depress latches
7. Battery pack
8. Reverse
9. Forward
10. Unlock (release)
11. Chuck jaws
12. Lock (tighten)
13. Drill bit
14. To decrease torque
15. To increase torque
16. Two-speed gear switch
17. High speed
18. Low speed
SPECIAL SAFETY RULES
Wear ear protectors. Exposure to noise can cause
hearing loss.
Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its cord. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.

SPECIFICATIONS

Voltage
Chuck
Switch
No-load speed (drill mode)
Low speed
High speed
Maximum torque
Weight (not including battery pack)
IT NL PT DK SE
12 V
0.8-10 mm
Variable speed
0 - 400 min-1
0 - 1380 min-1
25 Nm
1.01 kg
FI NO RU PL CZ
English
Model
LSDT1202

OPERATION

Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
VHFRQG LV VXI¿FLHQW WR LQÀLFW VHULRXV LQMXU\
Always wear eye protection marked to comply with
ANSI Z87.1. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
Drilling in all types of wood products (lumber,
plywood, paneling, composition board, and hard
board)
Drilling in ceramics, plastics, fiberglass, and
laminates
Drilling in metals
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
VSHFL¿FDWLRQV VHFWLRQ
BATTERY PROTECTION FEATURES
Ryobi lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximize battery life.
Under some operating conditions, these built-in features
may cause the battery and the tool it is powering to act
differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to stop
running. To reset the battery and tool, release the trigger
and resume normal operation.
1
HU RO LV LT EE
Battery pack Compatible
(not included) (not included)
BPL1220
C120D
BPN1213
BPN1213 C120N
WARNING
WARNING
WARNING
HR SI SK GR TR
charger