Technical Data; Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-PH 150 Originalbetriebsanleitung

manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Max. permitted pressure: ........................... 16 bar
Hose length: ........................................15 + 1.5 m
Weight: ...................................................... 5.8 kg
5. Before using the equipment for
the fi rst time
5.1 Assembly (Fig. 2)
The hose reel can either be suspended by the
suspension eyelet (5) or attached to a wall or cei-
ling using the mounting bracket (4).
Danger! Before drilling any holes, make sure that
there are no electric cables or other installations
(e.g. water pipes) where you are drilling. Ensure
that the unit is secured fi rmly on the wall and that
it is horizontal. Only use suitable fastening ma-
terials and make sure that the wall is capable of
bearing the load.
The supplied wall plugs and screws are suitable
for the following:
Concrete, natural stone with a dense structure,
solid bricks, solid limestone bricks, solid light-
weight concrete bricks, and aerated concrete.
5.2 Connections
Hose (1) to the connection on the compressor
Hose (2) to the connection on the compressed
air tool

6. Operation

6.1 Uncoiling
Pull out the hose (2) to the desired length from
the hose reel (3). The length of the hose will au-
tomatically be locked if you let go of the hose (2)
while the grating sound is audible.
Anl_TC_PH_150_SPK13.indb 11 Anl_TC_PH_150_SPK13.indb 11
GB
6.2 Coiling up
The lock can be released with a short pull on the
hose (2). Then feed the hose (2) evenly back into
the hose reel.
The position of the hose stopper (6) can be adjus-
ted to suit the required hose length. No tools are
required for this.
Warning! The locking mechanism generates a
grating sound when the hose is being uncoiled or
coiled back up.
7. Cleaning, maintenance and
ordering of spare parts
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
- 11 -
29.10.2021 11:08:53 29.10.2021 11:08:53