Password Setting - Bräunlich QU376D Bedienungsanleitung

1.11.
The initial password in station's memory is "000". The setting
temperature is admitted in this state. If need to restrict the setting
temperature, the password must be changed
Enter into setting the password
1. Turn off the power switch. Press and hold the "▲"and"▼ buttons
simultaneously, then turn on the power switch.
2. Continue holding down the "▲"and "▼"button until the display shows
.
3. When the display shows
mode.
Input Previously Password
4. Press the "*" button, the display shows
digit (the 100's digit) in the display will flash. This indicates the
station is in password setting mode and the 100's digit can be
adjusted. Using the "▲"or "▼"button will change displayed value. Set
the password value in the same way described in "set temperature
normally". After selecting the password of three digit, press"*"
button.
The input password is error
5. If the display window shows the present setting temperature, two
seconds later, the station is in normal work state. This indicates the
password of input is error, and the temperature setting can't be done.
The password of input is correct

Password Setting

,the station is in parameter-input
18
USER MANUAL
, and the left-most