Duravit DuraSystem WD5003 Bedienungsanleitung Seite 59

Problem
Hygiene flush
Hygiene flush does not work
Hygiene flush occurs too often
or too seldom
Hygiene flush occurs at an
inappropriate time
Odour extraction
Odour extraction starts
automatically
Odour extraction does not
start automatically
Extraction power is not
satisfactory
Odour extraction stops
immediately after you leave
the toilet
Odour extraction does not stop
immediately after you leave
the toilet
Night light function
Night light does not light up
Night light lights up
continuously
58
Potential cause
Actuator plate has been used
since the last hygiene flush
Hygiene flush is deactivated
Number of flushes is
incorrectly set
The starting time is
incorrectly set
Automatic mode is activated
Manual mode is activated
Extraction power is not
optimally adjusted
Run-on time set to 0 min
Run-on time is set to a value
greater than 0 min
Night light is deactivated
Ambient light is too bright
Ambient light is too low
Actuator plate is dirty or wet
Solution
>
Hygiene flush will occur at
the end of the next interval.
>
Activate the hygiene flush.
>
Adjust the number of flush
packages.
>
Adjust the starting time.
>
Factory settings.
>
Adjust the mode if
necessary.
>
Adjust the mode.
>
Adjust the extraction power.
>
Active or extend the run-on
time.
>
Deactivate or reduce the
run-on time.
>
Activate the night light.
>
Deactivate the night light.
>
Clean or dry the actuator
plate.