Before Using The Appliance; Preparing Your Dishwasher For First Use; Salt Usage (If Available); Fill The Salt (If Available) - IKEA TILLREDA AA-2326089-2 Bedienungsanleitung

4. BEFORE USING
THE APPLIANCE
4.1. Preparing your
dishwasher for first use
• Make sure the electricity and supply
water specifications match the
values indicated in the installation
instructions for the machine.
• Remove all packaging material inside
the machine.
• Set the water softener level.
• Fill the rinse aid compartment.

4.2 Salt usage (IF AVAILABLE)

For a good washing function, the
dishwasher needs soft, i.e. less
calcareous water. Otherwise, White
lime residues will remain on the dishes
and the interior equipment. This will
negatively affect your machine's washing,
drying and shining performance. When
water flows through the softener system,
the ions forming the hardness are
removed from the water and the water
reaches the softness required to obtain
the best washing result. Depending on
the level of hardness of the inflowing
water, these ions that harden the
water accumulate rapidly inside the
softener system. Therefore, the softener
system has to be refreshed so that it
operates with the same performance
also during the next wash. For this
purpose, dishwasher salt is used.
Machine can only be used by special
dishwasher salt to soften the water.
Do not use any small grained or
powdered type of salts which can
easily soluble. Using any other type
of salt can damage your machine.

4.3. Fill the salt (IF AVAILABLE)

To add softener salt, open the salt
compartment cap by turning it counter
clockwise. (1) (2) At first use, fill the
compartment with 1 kg salt and water (3)
until it is almost overflowing. If available,
using a funnel (4) will make filling easier.
Replace the cap and close it. After every
20-30 Cycles add salt into your machine
until it fills up (approx. 1 kg).
1
3
Only add water to the salt
compartment on first use.
Use softener salt specifically produced
for use in dishwashers.
When you start your dishwasher, the
salt compartment is filled with water,
therefore put the softener salt in prior to
starting your machine.
If the softener salt has overflowed
and you do not start the machine
immediately, run a short washing
program to protect your machine against
corrosion.
GB - 9
2
4