Safety; Intended Use Of The Product; User Requirements; General Safety Instructions - HOLZMANN-MASCHINEN UB70 Betriebsanleitung

10

SAFETY

This section contains information and important notes on safe commissioning and handling of the
product.
For your personal safety, please read these operating instructions carefully before
commissioning. This will enable you to handle the product safely and prevent
misunderstandings as well as personal injury and damage to property. Also observe
the symbols and pictograms used on the product as well as the safety and danger
information!

10.1 Intended use of the product

The product is intended exclusively for the following activities:
For cold and warm bending of flat, round, square bar steel, aluminium or similar material within
the specified technical limits.
HOLZMANN MASCHINEN
beyond this and for any resulting damage to property or injuries.

10.1.1 Technical restrictions

The product is intended for use under the following ambient conditions:
Rel. Humidity:
Temperature (operational)
Temperature (Storage, Transport)

10.1.2 Prohibited use / Forseeable misuse

- Operation of the product without adequate physical and mental aptitude
- Operating the product without knowledge of the operating instructions
- Changes in the design of the product
- Operating the product outside the limits specified in this manual
- Remove the safety markings attached to the product.
- Modify, circumvent or disable the safety devices of the product.
The improper use or disregard of the versions and instructions described in this manual will result
in the voiding of all warranty and compensation claims against Holzmann Maschinen GmbH.

10.2 User requirements

The physical and mental suitability as well as knowledge and understanding of the operating
instructions are prerequisites for operating the product. Persons who, because of their physical,
sensory or mental abilities or their inexperience or ignorance, are unable to operate the product
safely must not use it without the supervision or instruction by a responsible person.
Please note that local laws and regulations may stipulate the minimum age of the operator and
restrict the use of this product!
Put on your personal protective equipment before working on the product.

10.3 General safety instructions

To avoid malfunctions, damage and health hazards when working with the product, in addition to
the general rules for safe working, the following points must be observed:
 Before commissioning, check the product for completeness and function.
 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the product!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects!
 Only use perfect tools that are free of cracks and other defects (e.g. deformations).
 Remove setting tools from the product before switching on.
 Keep the area around the product free of obstacles (e.g. dust, chips, cut workpiece parts
etc.).
HOLZMANN MASCHINEN GmbH
assumes no responsibility or warranty for any other use or use
www.holzmann-maschinen.at
max. 65 %
+5° C bis +40° C
-20° C bis +55° C
SAFETY
14
UB70 | UB100 | UB100A