ION Luxe LP Benutzerhandbuch Seite 9

I am connected to a Bluetooth speaker but do not hear any audio.
•
Use the Bluetooth Volume knob on Luxe LP to turn up the Bluetooth output level.
•
If you are connected to a Bluetooth speaker with a play button, try pressing the play button.
Alternatively, try pressing the Bluetooth button on Luxe LP.
•
Press and hold Luxe LP's Bluetooth button to disconnect it from the Bluetooth speaker. Then
press and release the Bluetooth button to pair again.
•
Turn Luxe LP off and then on again, and then press its Bluetooth button to pair again.
My smartphone will not connect to Luxe LP Turntable.
•
Luxe LP Turntable acts as a Bluetooth Transmitter, sending the audio out of Luxe LP into other
Bluetooth Speakers. Luxe LP Turntable cannot act as a Bluetooth Receiver and play music from
your smartphone over headphones or RCA outputs.
The Bluetooth LED will not stop blinking.
•
Once the Bluetooth button is pressed, Luxe LP will try to connect to nearby Bluetooth speakers
for 1 minute. To stop the blinking Bluetooth LED, power cycle Luxe LP.
I am hearing an echo when listening to music.
•
Either listen to music through a paired Bluetooth speaker or connect the RCA audio outputs from
Luxe LP to a speaker. Both playback methods should not be used at the same time.
I am hearing static noise in my headphones.
•
Press Luxe LP's Bluetooth button to disconnect it from a paired Bluetooth speaker. When
listening to Luxe LP with headphones, always make sure Luxe LP is not connected to a Bluetooth
speaker at the same time.
Setting Luxe LP as the Default Recording Device
•
Windows XP: Click Start Menu  Control Panel (or Settings  Control Panel in Classic View) 
Sound and Audio Devices. Click the Audio tab and under Sound recording, select USB PnP
Audio Device as the default device.
• Windows Vista: Click Start Menu  Control Panel (or Settings  Control Panel in Classic View)
 Hardware and Sound  Sound. Click the Recording tab and select USB PnP Audio Device
as the default device.
• Windows 7: Click Start Menu  Control Panel  Sound. Click the Recording tab and select
USB PnP Audio Device as the default device.
•
Windows 8: From the Start Menu, click the lower-left corner of the screen to bring yourself to the
Desktop.
In the bottom-right corner of the Taskbar, locate the Volume Control "Speaker" icon. Right-click
the speaker and select Playback Devices. In the Windows Sound control panel select the
Recording tab.
If USB PnP Audio Device does not have a green "check mark" symbol next to it, right-click it and
select "Set as Default Device".
•
macOS: Click the upper-left "apple" icon then click System Preferences  Sound. Click the
Input tab. From the menu, select USB PnP Audio Device as the device.
9