Husqvarna T 4000 Bedienungsanweisung Seite 8

glasses, protective gloves, and a breathing mask
conforming to protection class FFP3.
• Long-term exposure to noise can result in permanent
hearing impairment. Always use approved hearing
protection. Listen for warning signals or shouts when
you wearing hearing protection. Always remove your
hearing protection as soon as the engine stops.
• Use approved protective gloves when you do
maintenance on the product.
• Use tight-fitting, heavy-duty and comfortable clothing
that permits full freedom of movement. Do not wear
shorts.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
Introduction
CAUTION:
with correct rated value for this product. Only
connect to an outlet that is correct grounded.
Before use
WARNING:
extractor make sure that the power and
voltage corresponds with the voltage shown
on the machines rating plate, including
extension cords.
WARNING:
grounded outlet only. Refer to
instructions on page 8
Grounding instructions
WARNING:
be grounded. If it should malfunction or
breakdown, grounding provides a path
of least resistance for electric current to
reduce the risk of electric shock. The dust
extractor is equipped with a cord having
an equipment-grounding conductor and
grounding plug. The plug must be inserted
into an appropriate outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
8
Read the warning
Assembly
Only use extension cable
Operation
Before using the dust
Connect to a properly
Grounding
The dust extractor must
• Make sure the engine switch is in the Off position.
Disconnect the product from the wall outlet.
• Do not modify the product from its original design.
• All repairs must be performed by a qualified
service person. Use only manufacturer-supplied or
equivalent replacement parts.
• Make sure that you use correct fuse when you do
servicing on the product.
• Use approved protective equipment. Refer to
Personal protective equipment on page 7
• Do not make a hole in the Hepa filter. A broken Hepa
filter can disperse dust.
CAUTION:
before change of bag collection system.
To start and stop
Push the green button (A) to start the dust extractor.
Push the red button (B) to stop the dust extractor.
A
Phase converter
Note:
Not applicable to variants sold in Australia or
New Zealand.
WARNING:
done by an approved electrician.
If the red lamp (A) between the red and the green button
lights up, there is a phase error. Switch 2 of the phases
to reset (B). This is a safety measure to make sure that
the pump does not start to blow.
Always clean the prefilter
B
Electrical work must be
877 - 006 - 03.02.2022